Assembly; Qc-E(Edger Attachment); Installing Debris Shield; Installing Edger Blade - Maruyama QC-E Manual Del Propietario U Operador

Assembly

QC-E (Edger Attachment)

Installing Debris Shield

WARNING
POTENTIAL HAZARD
• Foreign objects can be thrown by the
Edger.
WHAT CAN HAPPEN
• Contact with thrown objects can cause
personal injury.
HOW TO AVOID THE HAZARD
• Never operate the Edger without the
debris shield in place.
Debris Shield
Hex Nut
Lock Washer
Flat Washer
Collar
Plate Stud
1. Install the collar onto the plate stud.
2. Install the shield onto the plate stud, making sure the
shield stud fits into the matching slot in the plate.
3. Install the flat washer, lock washer and hex nut
onto the plate stud.
4. Install the flat washer and knob onto the shield stud.
Guard Stud
Plate
Flat Washer
Knob

Installing Edger Blade

POTENTIAL HAZARD
• If the Edger blade is not adequately
tightened, it can come loose from the
Edger during use.
WHAT CAN HAPPEN
• This may cause damage to property or
personal injury.
HOW TO AVOID THE HAZARD
• Make sure the Edger blade is securely
fastened to the attaching shaft in the
gearcase.
Gearcase
3 mm Hex Wrench
1. Install the boss adapter onto the splined shaft out
of the gearcase.
2. Install the edger blade, clamping washer and blade
bolt.
Note: The blade bolt has left-hand threads.
3. Align the hole in the boss adapter with the hole in
the gearcase.
4. Insert the 3 mm hex wrench into the holes in the
boss adapter and gearcase to lock the splined
shaft.
5. Tighten the blade bolt to 100 in.-lbs. (11.3 N·m).
6. Remove the 3 mm hex wrench from the boss
adapter and gearcase.
— US-10 —
CAUTION
Edger Blade
Attaching Shaft
Boss Adapter
Blade Bolt (left
hand thread)
Clamping Washer