Safety And Protective Devices - AL-KO BC 250 Manual Del Usuario

Safety and protective devices

Caution!
Safety and protective devices must not be disabled - injury danger!
Accelerator Lever
When released the device goes into an idle state. (Motor
continues to run, only the cutting platform stops) Monitor
this function regularly!
Emergency Stop
In the event of an emergency, switch to "STOP."
Residual risks
Even when the power tool is used as prescribed it is not possible to eliminate all residual risk factors. The following
hazards may arise in connection with the power tool's construction and design:
Damage to lungs if an effective dust mask is not worn
„
Damage to hearing if effective hearing protection is not worn
„
Damages to health resulting from vibration emission if the power tool is being used over longer period of time or not
„
adequately managed and properly maintained
Specification
Motor type
Cylinder capacity
Dry weight
Tank capacity
String-cutting works
Drive-shaft length
Grip
Ignition
Drivetrain
Sound Pressure Level (EN ISO 11806) (K=1.5)
Sound power levels (2000/15/EG+2005/88/EG) (K=1.5)
Guaranteed sound power levels (2000/14/EG+2005/88/EG)
Vibration strength under full load (K=1.5)
vibration strength in an idle state (K=1.5)
Maximum motor performance
Motor rotational speed
Recommended maximum spindle rotational speed
Idle-state speed
Fuel Consumption
470 007_e
Stone impact - protective shield
Protects the operator from propelled objects. The integrated
cutter shortens the cutting string to the permissible length.
Exhaust pipe guard
Guards from contact with hot exhaust gas.
Air-cooled, 2-cycle, chrome cylinder
26cm
3
5.92 kg
550 cm
3
Double-string cutting works,
76,2 cm + 61 cm
"D" grip
Electronic
Centrifugal Clutch
101 dB(A)
116 dB(A)
118 dB(A)
11.5 m/s
2
3.8 m/s
2
0.78 kW
8500 min
-1
8500 min
-1
3000 ± 300 min
-1
415 g / kWh
GB
43 cm
17