Kettler MULTI-FITNESS–CENTER Manual Del Usuario página 3

GB Assembly Instructions
Before assembling or using the Fitness Center, please read the following instructions carefully. They contain important
information for use and maintenance of the equipment as well as for your personal safety. Keep these instructions in a
safe place for maintenance purposes or for ordering spare parts.
For Your Safety:
■
The Fitness Center should be used only for its intended pur-
pose, i.e. for physical exercise by adult persons.
■
Any other use of the equipment is prohibited and may be dan-
gerous. The manufacturer cannot be held liable for damage or
injury caused by improper use of the equipment.
■
The Fitness Center „DELTA" has been designed in accordance
with the latest standards of safety. Any features which may
have been a possible cause of injury have been avoided or
made as safe as possible.
■
The unit complies with class H of the standard EN 957.
■
Incorrect repairs and structural modifications (e.g. removal or
replacement of original parts) may endanger the safety of the
user.
■
Damaged components may endanger your safety or reduce
the lifetime of the equipment. For this reason, worn or dam-
Handling the equipment
■
Before using the equipment for exercise, check carefully to en-
sure that it has been correctly assembled.
■
During exercise, ensure that all the necessary safety elements
are in place and that they cannot work loose.
■
Do not set the equipment up in rooms which are frequently
used or close to doors, entries etc.
■
Do not store or use the equipment in damp rooms.
■
The surface on which the Fitness Center is placed must be firm
and even. Place rubber or straw mats under it to deaden any
noise or impacts. Do not allow the weights to drop from a
height.
Instructions for Assembly
■
Ensure that you have received all the parts required (see check
list page 9) and that they are undamaged. Should you have
any cause for complaint, please contact your Kettler dealer.
■
Before assembling the equipment, study the drawings carefully
and carry out the operations in the order shown by the dia-
grams. The correct sequence is given in capital letters.
■
The fastening material required for each assembly step is
shown in the diagram inset. Use the fastening material exactly
List of spare parts page 25-31
When ordering spare parts, always state the full article
number, spare-part number, the quantity required and the
inspection number stamped on the back.
Example order:
Art. no. 7713-000 / spare-part no. 94315098 /
1 pieces / inspection no......
aged parts should be replaced immediately and the equipment
taken out of use until this has been done. Use only original Ket-
tler spare parts.
■
In case of enquiry, please contact your Kettler dealer.
■
If the equipment is in regular use, check all its components thor-
oughly every 1 - 2 months. Pay particular attention to the tight-
ness of bolts and nuts.
■
Instruct persons using the equipment (in particular children) on
possible sources of danger during exercising. This applies in
particular to the use of the weights.
■
Before beginning your program of exercise, consult your doc-
tor to ensure that you are fit enough to use the equipment. Base
your program of exercise on the advice given by your doctor.
Incorrect or excessive exercise may damage your health.
■
The Fitness Center is designed for use by adults and children
should not be allowed to play with it. Children at play behave
unpredictably and dangerous situations may occur for which
the manufacturer cannot be held liable. If, in spite of this, chil-
dren are allowed to use the equipment, ensure that they are in-
structed in its proper use and supervised accordingly.
■
Do not use corrosive or abrasive materials to clean the equip-
ment. Ensure that such materials are not allowed to pollute the
environment.
as instructed. The required tools are supplied with the equip-
ment.
■
The equipment must be assembled with due care by an adult
person. It is recommended to carry out the assembly work with
two persons.
■
For technical reasons, we reserve the right to carry out prelim-
inary assembly work (e.g. addition of tubing plugs).
■
Ensure that the ropes are correctly and firmly knotted.
Important: spare part prices do not include fastening ma-
terial; if fastening material (bolts, nuts, washers etc.) is re-
quired, this schould be clearly stated on the order by ad-
ding the words „with fastening material".
Kettler (GB) Ltd. · Kettler House, Merse Road · North Moons Moat ·Red-
ditch, Worcestershire · B98 9HL · Great Britain
Kettler International Inc. · 1355, London Bridge Road · USA-Virginia
Beach, Virginia 23450
3