Assembly Optional Floor Fastening - Extremis EXTEMPORE Manual De Instrucciones

OPTIONAL FLOOR FASTENING
WHAT YOU NEED
2 people
no. 13 spanner
no. 4 hex key
+/- 15 min.
2. Insert the 4 identical stainless steel rods into the holes
provided for that purpose.
4. Put the table or the bench (without fitting the legs) on
the spot where you intend to fasten it to the ground.
6 assembly floor fastening
1. Put the table or the bench on the ground with the
wooden side facing downwards. Use the packaging
mate- rial to protect the wooden surface.
3. Screw down the rods using a no. 13 wrench. Do not
tighten them too much as this may cause them to
break.
5. Mark the spots where the rods touch the ground. Then
move the table or the bench and fit the legs as explained
in the Extempore manual.