Sauder Costa 419958 Instrucciones De Montaje página 8

Step 4
Fasten the UPRIGHTS (D and E) to the TOP (T). Tighten
å
four TWIST-LOCK® FASTENERS.
Slide the CENTER BACK (O) into the grooves of the
å
UPRIGHTS (D and E).
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the
adjoining part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoining part while locking
the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight
as possible.
Dowel end
Meet Part (T). This component has
been engineered to be lighter, stronger,
faster... well ok. Not technically faster.
But defi nitely makes for a sturdier
Hutch that' s easier to assemble and
friendlier to the environment.
Page 8
®
FASTENER
D
These holes must be here.
419958
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
O
F i n
i s h
e d
s u
r f a
c e
Groove
E
T
Just think. The sooner
you do this, the sooner
you do something else.
www.sauder.com/services