Black 1-1/8" Machine Screw - Sauder Costa 419958 Instrucciones De Montaje

Step 20
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten a DOOR (U) to the LEFT UPRIGHT (E) as shown
å
in the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a KNOB SET (136K) to the DOOR (U). Use a
å
BLACK 1-1/8" MACHINE SCREW (21S).
Repeat this step for the other DOOR.
å
See the next step for DOOR adjustments.
å
136K

BLACK 1-1/8" MACHINE SCREW

(2 used for the KNOB SETS)
Page 24
U
E
21S
419958
Stop
Mounting
screw
Hinge
www.sauder.com/services