Electrical Safety; Package Contents - DeWalt DW745 Traducido De Las Instrucciones Originales

- Risk of injury when changing the saw blade with unprotected hands.
- Risk of squeezing fi ngers when opening the guards.
- Health hazards caused by breathing dust developed when sawing
wood, especially oak, beech and MDF.
The following factors are of influence to noise production:
- the material to be cut
- the type of saw blade
- the feed force
The following factors are of influence to dust exposure:
- worn saw blade
- dust extractor with air velocity less than 20 m/s
- workpiece not exactly guided
Under consideration of the factors mentioned above, the dust collecting
efficiency is about 95% of breathable dust.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Wear respiratory protection.
Pull the plug from the socket when blade change or any
maintenance is needed.
Keep hands away from cutting area and the blade.
Carrying point.
DATE CODE POSITION
The Date Code, which also includes the year of manufacture, is printed
into the housing.
Example:
Year of Manufacture

Package contents

The package contains:
1 Partly assembled machine
1 Rip fence assembly
1 Mitre fence
1 Saw blade
1 Upper blade guard assembly
1 Table insert
1 Blade wrench
1 Arbor wrench
1 Dust extraction adapter
1 Instruction manual
1 Exploded drawing
2009 XX XX
• Check for damage to the tool, parts or accessories which may have
occurred during transport.
• Take the time to thoroughly read and understand this manual prior to
operation.
Description (fi g. A1 - A3)
A1
1 On/off switch
2 Circuit breaker reset button
3 Hand indentation
4 Table
5 Riving knife
6 Upper blade guard
7 Table insert
8 Parallel rip fence
9 Rip scale indicator
10 Fine adjustment knob
11 Combined elevating and bevel control wheel
12 Bevel lock lever
A2
13 Ripping position lock lever
14 Blade wrench storage
15 Push stick
16 Dust extraction adapter
17 Foot
18 Fence slot
A3
19 Mitre fence
INTENDED USE
Your DW745 jobsite table saw has been designed to perform the sawing
operation of ripping, cross-cutting, bevelling and mitring in wood, wood
products and plastics. This unit is designed for use with a ø 250 mm
carbide tip blade.
WARNING: Do not use the machine for other purposes as
intended.
DO NOT use under wet conditions or in presence of flammable liquids or
gases.
These table saws are professional power tools.
DO NOT let children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.

Electrical safety

The electric motor has been designed for one voltage only. Always check
that the power supply corresponds to the voltage on the rating plate.
115 V units have to be operated via a failsafe isolating
transformer with an earth screen between the primary and
secondary winding.
Your D WALT tool is double insulated in accordance with
E
EN 61029; therefore no earth wire is required.
If the supply cord is damaged, it must be replaced by a specially prepared
cord available through the D WALT service organisation.
E
E N G L I S H
21