Emerson CF930LBS00 Manual Del Propietário página 9

3. Ceiling Fan Assembly
3.13
Route the Three Motor Wires through the Hanger Ball
(Figure 13).
Reinstall the Hanger Ball on the 4.5" Downrod as
follows:
Position the Pin through the Two Holes in the
4.5" Downrod and align the Hanger Ball so the Pin is
captured in the Groove in the top of the Hanger Ball
(Figure 13).
Pull the Hanger Ball up tight against the Pin and
securely retighten the Phillips Head Set Screw in the
Hanger Ball (Figure 13).
A loose Phillips Head Set Screw could create fan
wobble.
3.14
The Fan comes with Black, Blue and White Wires that
are 80-inches long.
Before installing the Fan, measure up approximately
6 to 9-inches above top of Hanger Ball/Downrod
Assembly (Figure 14).
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires.
(Continued)
Figure 13
6 TO 9
INCHES
1/2
INCH
Figure 14
Please contact 1-800-654-3545 for further assistance
9
BLACK WIRE
BLUE WIRE
WHITE WIRE
HANGER BALL
emersonfans.com
U.L. Model No.: CF930L