Maintenance, Care, Storage; Troubleshooting - Brill 30 VE Manual Del Usuario

(fig. E pos. 6). The motor
switches off. The grass box can
be removed at the handle with
one hand.
In order to guarantee a good
filling result, you should clean the

9. Maintenance, care, storage

Accidents and equipment failure
can be prevented by regular
checks (screwed connections firmly
attached, cracks, damage) and by
replacing damaged or worn parts.
Repairs should only be undertaken
by authorised specialists on safety
grounds. A list of service centres is
enclosed with the equipment.
Warning! Always pull out
A
the mains plug before
undertaking any work, inspections
and repairs to the equipment.
Danger of damage to equipment:
never clean electrical equipment
under running water, in particular,
do not use water under high
pressure on it.
Store the equipment in a dry, frost
proof location.
Store where children cannot gain
access to the equipment.

10. Troubleshooting

General
Faults usually occur if the unit has
not been handled, cared for or
maintained properly. The following
table contains the most common
faults and remedies to eliminate
these faults. If you have any other
problems, please contact your
nearest service centre authorised
by the manufacturer, or your
nearest authorised specialist dealer.
grassbox and especially the air
grid (net / textile) after use.
Warning! Do not remove any
A
deposits from the housing
by hand or with your shoe, but
with suitable aids, e. g. brush.
Maintenance
Maintenance refers to any work
needed to keep the equipment in
perfect operating condition. Have
your aerator regularly services by
a service point which is authorised
by the manufacturer or an
authorised specialist workshop.
Care
Dirt and grass residue can be
removed easiest directly after the
aeration. Disconnect from the
mains and lay the implement on
its side. Clean with a brush.
Warning! The aerator is
A
not to be cleaned with run-
ning water, especially not under
high pressure.
Storage
Allow the motor to cool down
before placing the machine in an
enclosed space.
The guide rods can be folded
together in order to save space
Caution! Repairs that
A
require specialist
knowledge must only be carried
out by an authorised specialist.
Caution! For safety reasons,
A
only use original spare
parts supplied by the manufacturer
or parts that have been authorised
by the manufacturer.
After emptying the grass box,
replace it in the retainer provided.
Warning! Only replace the
A
grass box when the motor
is switched off and the cutting tool
is stationary.
as shown in Figure B. Position the
control lever (fig. D Pos. 3) at
Position P (Park) so that the blade
is unable to make contact with
the ground.
You can store the lawn aerator as
shown in (Figure H. To do so,
loosen the hinged tension handle
(fig. A, Pos. 2) until the guide
attachments are released, fold the
guide attachments up and screw
the hinged tension handles tight so
as to ensure that the guide attach-
ments are unable to fall over when
being stood up.
Warning! When folding
A
together, ensure that the
cable is not creased or squeezed.
For storage, you can coil the short
32 VE scarifier cable around the
holder provided on the operating
panel as shown in (fig. I).
Warning! The cable must
A
be completely unwound
before starting to work with this
appliance.
We expressly point out that in
accordance with product liability
laws, we are not liable for any
damage caused by our units if this
damage is due to improper repair
or if parts exchanged are not our
original parts or parts approved
by us, and if the repairs were not
carried out at service centre
authorised by the manufacturer
or by an authorised specialist.
The same applies to spare parts
and accessories.
GB
19