Product Description - Renfert AUTO spin Guia De Inicio Rapido

► Damaged equipment must be taken out of service immediately. Disconnect from mains and secure
against being switched on again. Send the device in for repair!
► Observe national accident prevention regulations!
EN ► Information on REACH and SVHC is available on our website www.renfert.com, in the Support
area.
Specific information
► Caution Laser beam Class 2 laser. Do not look directly into the beam!
Do not look into the beams reflected by specular surfaces.
► Never touch the drill while the unit is connected to the power supply. Inadvertently starting the
unit can result in injury!
► Always keep long hair, loose or wide sleeves or other clothing away from the AUTO spin. Hair or
clothing can be pulled into and wrapped up on the grinding wheel, resulting in injury!
► Do not touch the rotating drill.
► Operation of the device only with the plate holder in place and plastic plate inserted.
Risk of injury from rotating drill.
► Do not reach under the drilling table during operation, risk of crushing.
► Do not grasp between the drill bit and the drill table during operation, risk of crushing. Risk of
injury from rotating drill.
Approved personnel
The appliance may only be operated and serviced by trained personnel.
Unit must not be used by persons with restricted physical, sensory or mental capabilities, or those lacking
the relevant operating experience.

Product description

Assemblies and functional elements
See Fig. 1 (on inside cover)
1 Target laser
2 Drilling table with holding magnets
3 Operating indicator
4 Opening for level controller
5 Laser warning
6 Operating key, left/right
Standard Delivery
1 AUTO spin
1 Drill
1 Plate holder
1 Impression holder
1 Level controller
1 Adjusting tool for drilling depth
(screwdriver Torx T5)
Commissioning
Unpacking
⇒ Check the delivery for completeness (compare with the "Standard Delivery").
Setup
⇒ Place the unit on a flat, stable surface.
Do not lift or carry the device by the laser arm.
7 Power cord with mains plug
8
Plate holder
9 Impression holder
10 Level controller
11 Adjusting tool for drilling depth
(screwdriver Torx T5)
12 Tool for drill fixing (angled Torx T10)
1 Tool for drill fixing (angled Torx T10)
1 Laser sticker set
1 Quick Start Guide
1 AUTO spin system illustrated manual
- 2 -