Electrical Connection - Renfert AUTO spin Guia De Inicio Rapido

Replacing the "Laser warning"
⇒ Remove the laser warning in your language from the sticker set and cover over the existing warning
label (5).

Electrical connection

⇒ Unroll the power cord and insert the power plug into the building wall socket.
Moving to the start position
If the drill motor is not in its starting position, this is identified and displayed after plugging in the mains
plug:
In this case:
♦ The operating indicator (3) flashes.
⇒ Press and hold both operating keys (6).
♦ The drill motor slowly moves to the starting position.
♦ As soon as the start position is reached, the motor stops and the operating indicator lights up perma-
nently.
Operation
Power on / off
The device is switched on and off by pressing one of the operating keys (6).
⇒ To switch on the device, briefly press an operating key.
⇒ To switch off the device, press an operating key for approx. 2 sec.
Auto Off
The device also includes an automatic shutdown feature. If the device is not used for 3 minutes, it turns
off automatically.
Level controller
The level controller (10) enables safe planning of the finished model situation.
• No collisions of the pin with the impression.
• No uneven or too high dental arches.
The stroke of the gauge tip in the level controller corresponds to a pin length of 14 mm.
For further handling, please refer to the enclosed AUTO spin system illustrated manual.
Drilling
⇒ Carry out the work steps for creating the model prior to drilling according to the enclosed AUTO spin
system illustrated manual.
⇒ Place the prepared unit (plate and impression holder with impression and plastic plate) on the drilling
table.
⇒ Align so that the target laser points on the position of the desired pin hole in the impression.
⇒ Press both operating keys (6) simultaneously to initiate the drilling process.
♦ The holding magnets secure the plate holder in the desired position.
♦ The drill motor starts and drills a hole from below into the plastic plate.
♦ The drill motor returns to its start position and stops
♦ The holding magnets release the plate holder.
Caution
Danger of drill breakage.
► When aligning the target laser, always make sure that the plate holder or metal disc of the plastic
plate do not get drilled.
► If the plastic plate is to be used several times, ensure that there is a sufficient distance to already
existing drill holes.
Regularly remove plastic chips that get stuck to the drill.
Remove loose plastic chips from the drill table.
- 3 -
EN