Symbols Used; Unapproved Use; Hazards And Warnings - Renfert AUTO spin Guia De Inicio Rapido

Introduction
This Quick Start Guide contains instructions on the operation of the product and
relevant safety information.
For detailed information about the device, see the instructions for use which you
can download from our website at www.renfert.com/p915.
Enter the following item number: 18600000.

Symbols used

This manual contains symbols also found on the appliance itself with the following meaning:
Danger
Immediate risk of injury. Consult accompanying documents!
Electrical current
This indicates a risk of injury due to electrical current.
Laser
Do not look into the laser beam.
Caution
Risk of damage to the unit if the instruction is not followed.
Notice
A general notice that improves and eases use.
The appliance complies with applicable EU directives.
Within the EU, this device is subject to the provisions of the directive 2002/96/EC
(WEEE directive).
Other symbols are explained when displayed.
Safety
Correct use of the unit
The device is a system component for the production of dental section models with a plastic plate as base
support.
The device is used to make conical holes in these plastic plates made of POM.

Unapproved Use

Only plastic plates made of POM may be used. The device is not suitable for drilling plastic plates of
PMMA (Plexiglas) or other materials.
The device is not suitable to drill in plaster.

Hazards and Warnings

General information
► Granted protection is not given any longer in case the unit is not operated according to the in-
struction manual on hand.
► The unit should only be operated using a mains cable with a country-specific plug system. Any
modification required should only be carried out by an electrician.
► The unit should only be operated if the data on the rating plate corresponds with the data of re-
gional mains voltage.
► The unit should only be plugged into earthed sockets.
► The mains socket should be easily accessible.
► Disconnect the unit from the mains before working on electrical parts.
► It is the responsibility of the operator that national regulations during operation and regarding a
repeated safety inspection of electrical equipment are complied with. For Germany these are the
regulation 3 by DGUV (German Statutory Accident Insurance) in relation with VDE 0701-0702
(Association for Electrical & Electronic Technology).
► Regularly check connecting cables (such as power cables), hoses and housing (for example, the
control panel) for damage (for example, kinks, tears, porosity) or deterioration due to aging.
Do not operate units with damaged connection cables, hoses or housing parts or other defects!
- 1 -
EN