Wall-Mounting The Vb1 - Bose VIDEOBAR VB1 Manual Del Usuario

Wall-mounting the VB1

For best performance, follow these recommendations when setting up the VB1 on a
wall:
When determining where to attach the wall-mount bracket to the wall, make sure
there is enough space around the bracket to fit the VB1:
There must be at least 3.8 cm (1.5 in) above the wall-mount bracket. This will
allow you to "hang" the VB1 on it (Step 7) and to adjust the angle of the VB1. It
will also provide enough space to access the rear-panel connections on the VB1.
There must be at least 11.4 cm (4.5 in) below the wall-mount bracket. This will
allow you to hang the VB1 vertically during installation to insert cables and to
adjust the angle of the VB1.
The space must be at least 73.7 cm (29.0 in) wide—with the wall-mount bracket
in the center of it. This is necessary to accommodate the VB1 plus space to access
the acoustic port and buttons on the sides of the VB1 (there should be 2.5 cm
(1.0 in) on each side).
Only use the included hardware to mount this product.
Note: Some additional tools are required.
Note: Read the included Important Safety Instructions before continuing.
SETU P
|
1 4 E N