Bose VIDEOBAR VB1 Manual Del Usuario página 22

I
To fasten the power supply cord to the wall:
1. Determine where on the wall you want to fasten the power supply cord.
2. Mark a screw hole on wall.
3. If that part of the wall has a stud behind it, drill a 2.4 mm (3/ 3 2 in) hole into the wall.
If that part of the wall has no stud behind it, drill a 5 mm (3/ 1 6 in) hole into the wall.
4. If that part of the wall is has no stud behind it, drive the small drywall anchor (J)
into the wall.
5. Align the eyelet of the cable tie (I) with the screw hole.
6. Drive the small flat-head screw (H) into the eyelet of the cable tie to secure it to
the wall.
SETU P
J Small drywall anchor
K Small flathead screw
|
2 2 E N