General Information; Clean The Machine; Install The Cutting Line; Replace The Spool - GreenWorks 82T16 Manual Del Operador

EN
10.1

GENERAL INFORMATION

Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Store the machine in cool and dry place.
• Use correct clothing, protective gloves and safety glasses.
10.2

CLEAN THE MACHINE

• Clean the machine after use with a moist cloth dipped in
neutral detergent.
• Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
• Keep the trimmer head free of grass, leaves, or excessive
grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
• Do not spray water onto the motor and electrical
components.
10.3

INSTALL THE CUTTING LINE

Do not put more than 15 feet of cutting line in at a time.
1. Remove the remaining cutting line on the spool.
2. Line up the slots on the spool cap with the slots on the
trimmer head.
3. Put the cutting line through the hole. Push the cutting line
until it exits the opposite hole.
IMPORTANT
NOTE
English
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
5. Turn the spool cap clock-wise to wind the cutting line
into the trimmer head. Keep approximately 5 in of cutting
line above out of each side of the trimmer head.
5.1"
(130 )
mm
=
10.4

REPLACE THE SPOOL

1. Push the tabs (19) on the sides of the trimmer head at the
same time.
10
5.1"
(130 )
mm
=