Unpack The Machine; Attach The Guard; Attach The Auxiliary Handle; Install The Battery Pack - GreenWorks 82T16 Manual Del Operador

8.1

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
8.2

ATTACH THE GUARD

WARNING
Do not touch the cut-off blade.
1. Put the shaft into the groove of the guard.
2. Put the bracket (13) into the slot (14).
3. Align the screw hole on the bracket with the screw hole
on the guard.
4. Tighten the screws.
14
13
8.3 ATTACH THE AUXILIARY
HANDLE
1. Remove the knob (16) from the handle.
English
2. Attach the auxiliary handle and lower clamp (17) on the
shaft.
3. Set the auxiliary handle in the comfortable position.
4. Put the bolt (15) through the holes.
5. Tighten the auxiliary handle with the knob.
4
8.4

INSTALL THE BATTERY PACK

• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.5

REMOVE THE BATTERY PACK

1. Push and hold the battery release button (1).
2. Remove the battery pack from the machine.
7
15
16
WARNING
EN
17