Replace The Cutting Line; Remove The Trimmer Head - GreenWorks 82T16 Manual Del Operador

2. Pull and remove the spool cover (20).
20
21
3. Remove the remaining spool (21).
4. Put the spool in the spool housing.
Make sure that you put the cutting line in the slot on the
new spool and extend the line approximately 15 cm before
you install the new spool.
5. Put the ends of the cutting lines through the holes.
6. Extend the cutting line to release it from the guide slot in
the spool.
7. Push the tabs and install the spool cover onto the spool
housing.
8. Push the spool cover until it clicks into position.
10.5

REPLACE THE CUTTING LINE

NOTE
Remove the remaining cutting line on the spool.
Use only with the nylon cutting line of 0.094" (2.4 mm)
diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend the line at the midpoint and hook the loop into the
slot in the center rim of the spool. Make sure that the line
snaps into position in the slot.
19
NOTE
NOTE
English
3. With your finger between the lines, wind the lines equally
and tightly around the spool in the indicated direction.
4. Put the lines in the guide slots.
5. Do not wind the lines beyond the edge of the spool.
10.6

REMOVE THE TRIMMER HEAD

1. Put the metal rod (E) in the specified angle transmission
hole (D) to fix the trimmer head.
2. Remove the spool cover and the spool.
3. Loosen the nut (J) on the trimmer head clockwise with a
wrench.
4. Remove the trimmer head.
11
20
21
20
21
EN