Publicidad
3. Prepare Bumper Guard:
A.
Peel back the backing tape liner from each of the tape sections and fold at 45º, approximately 50mm (2") outside of the
Rear Bumper Guard (Figure 4).
B.
Fully remove the two backing tape liners from each end (Figure 5).
C.
Do not touch the exposed surface of the backing tape.
Figure 5
4. Trial and Fit Rear Bumper Guard:
A. Trial Fit the Rear Bumper Guard by aligning the centre mark of the part with the trunk latch (Figure 6) and align with
the die cut templates. Ensure that the adhesive tape does not overlap the die cut templates (Figure 7).
B. Apply light pressure to the tape areas.
C. Peel the backing tape liner away in the order shown in Figure 8.
Template
Inside Edge
06/06/19
Backing Tape Liner
Backing Tape Liner
Die Cut
Rear Bumper Guard
Figure 7
Figure 4
Figure 6
Page 10/18
Rear Bumper Guard
Die Cut
Template
2
Figure 8
3
1
SK713
Publicidad
