Publicidad
5. Apply Pressure to Rear Bumper Guard:
A.
Remove die cut templates and tape.
B.
Using a rubber roller, starting from the center out, press down the perimeter of part to ensure proper bond of
adhesive (Figure 9). Use caution to ensure roller does not scratch vehicle.
C.
Inspect for proper adhesion and placement. Verify the part is not loose at any corner.
D. Wipe the Rear Bumper Guard and bumper area to remove any marks or smudges.
NOTE: Do not wash vehicle through an automatic car wash for at least 24 hours.
06/06/19
Rubber Roller
Figure 9
Page 13/18
SK713
Publicidad
