Publicidad
1. Prepare Bumper:
A.
Open lift gate/trunk.
B.
Clean the tape attachment areas on the bumper thoroughly with the alcohol prep pad provided and allow to dry.
C.
Apply adhesion promoter directly onto the tape attachment areas of the bumper.
D.
Allow the adhesion promoter 5 minutes drying time once applied.
Rear Bumper
2. Position Side Templates:
A.
Fold the die cut templates at the dotted lines.
B.
Place the die cut templates into position at the rear bumper, aligning to the holes. (Figure 2).
C.
Tape into place (Figure 3).
Template
Align to Hole
Rear Bumper
06/06/19
Die Cut
Clean top surface of bumper
Figure 1
Figure 2
Page 7/18
Die Cut
Template
Tape x9
Die Cut
Template
Align to Hole
Align to Hole
Figure 3
SK713
Publicidad
