Characteristics; Factory Settings - Sime SOLO 25 ErP LN Instrucciones De Instalación

3

CHARACTERISTICS

3.1 COMBUSTION CHAMBER
DIMENSIONS (fig. 10)
The. combustion. chamber. is. a. direct.
passage.type.and.is.conform.to.the.EN.
303-3.standard.annex.E.
The.dimensions.are.shown.in.fig..10.
An. adequate. protection. panel. is.
mounted.on.the.inside.wall.of.the.rear.
head.of.all.the.models.
.
SOLO 25 ErP LN
SOLO 35 ErP LN
DUETTO 25 ErP LN
DUETTO 35 ErP LN
3.2 SYSTEM AVAILABLE HEAD
(fig. 11)
The. head. available. for. the. heating.
plant.is.shown.as.a.function.of.the.flow.
in.graph.in.fig..11.
3.3 HIGH EFFICIENCY PUMP
(fig. 11/a)
Press.the.button.(4).briefly.(about.1.sec-
ond).to.select.the.pump.operating.mode..
The.relative.LEDs.will.indicate.each.time.
the.adjustment.mode.(2).and.the.charac-
teristic.curves.set.(3)...
Point. 3.3.4. reports. the. possible. combi-
nations.and.their.meaning..
When. the. LED. (1). signals. a. fault,. the.
pump.stops.and.attempts.to.run.restart.
cycles..If.the.fault.is.solved,.the.pump.re-
starts.automatically.
3.3.1 Venting the pump
The. pump. venting. function. is. activated.
by.pressing.the.button.(4).for.a.long.time.
(3.seconds).and.vents.automatically.
3.3.2

Factory settings

The.factory.setting.is.activated.by.press-
ing.and.holding.the.button.(4).and.disa-
bling. the. pump.. When. the. pump. is. re-
started,.it.will.work.with.factory.settings.
(delivery.state).
3.3.3 Manual restart
When. a. lockout. is. detected,. the. pump.
76
L Volume
3
mm. dm
305. 17,5
405. 24,0
305. 17,5
405. 24,0
600.(58,8)
500.(49,0)
400.(39,2)
300.(29,4)
200.(19,6)
100.(9,8)
tries. to. start. automatically.. If. the. pump.
does. not. restart,. restart. manually. by.
pressing. the. button. (4). for. a. long. time.
(5.seconds),.then.release.it..The.restart.
270
594.(58,21)
601.(58,89)
535.(52,43)
0
200 400 600
L
492.(48,21)
455.(44,59)
400.(39,20)
321.(31,45)
239.(23,42)
800 1000 1200 1400 1600
PORTATA.(l/h)
FLOW.RATE.(l/h)
1 2
3
4
function.is.activated.for.a.maximum.of.10.
minutes..After.the.restart,.the.LED.indi-
cation.shows.the.previously.set.values..
If.the.fault.persists,.replace.the.pump..
Fig..10
1800
Fig..11
Fig..11/a