Atlantic Panama A Serie Instrucciones De Instalacion Y De Uso página 33

If the pilot wire is connected to a programming control unit, a timer or controller, programming of the heat
pump should not be done, or as appropriate, programming with the same temperature periods on both
systems.
Your unit is in Comfort mode:
Command on your
programming box
COMFORT
COMFORT -1°C
COMFORT -2°C
ECO ( )
Comfort -3°C
FROST PROTECTION
( )
fixed setpoint + 7°C
TURNED OFF
NB :
In the absence of pilot wire command, the device will operate at the temperature set with the buttons
Turned Off and Frost Protection commands have priority over
CONF
This mode allows you to have the desired room temperature. The fan adjusts its speed to the needs.
HOW TO ACTIVATE THIS MODE?
If the screen is not illuminated, just press any key to turn it on.
To activate the Comfort mode, press
several times on
arrow is on COMFORT mode
During the cooling cycle, the recommended Comfort temperature is 26°C. It can vary between 17.5°C and
33°C.
To change the displayed
temperature, press on
or .
Room temperature set in Comfort mode.
CONF is turned on.
CONF is turned on. The room temperature stabilizes at -1°C at Comfort
temperature.
CONF is turned on. The room temperature stabilizes at -2°C at Comfort
temperature.
CONF is turned on.
The Comfort temperature cannot be changed because the programming order is
Eco.
CONF is turned on.
Heating or cooling immediate shutdown (
is displayed when you press on a button and then turns off.
COOLING YOUR ROOM:
until the selection
HOW TO CHANGE THE DESIRED TEMPERATURE?
Lowering
and
and
used for load shedding
ECO and Comfort
COMFORT
DESCRIPTION
The temperature set in Comfort mode will
be displayed.
The screen then goes to sleep.
The selected temperature is displayed on the
screen. The fan is running.
14
are alternatively displayed.
are alternatively displayed.
).
CONF modes.
MODE
and