2-9.2. 1080I Hd Mode Adjustment; 2-9.3. Vertical Compressed Mode Check And Confi Rmation - Sony TRINITRON KV-42DRC700 Manual De Instrucciones

CXA2150D-1
0. VPOS (V-POSITION)
1. VSIZ (V-SIZE)
2. VLIN (V-LINE)
3. VSCO (VS-COR)
7. HTPZ (H-TRAPEZOID)
CXA2150D-2
1. HPOS (H-POSITION)
2. HSIZ (H-SIZE)
5. PIN (PIN AMP)
6. UCP (UP COR PIN COR)
7. LCP (LOW CO PIN COR)
13. PPHA (PIN PHASE)
14. VANG (AFC-ANGLE)
15. LANG (L-ANGLE)
16. VBOW (AFC-BOW)
17. LBOW (L-BOW)

2-9.2. 1080i HD MODE ADJUSTMENT

1. Input a 1080i cross-hatch signal and an HD monoscope signal that
contains overscan markers.
2. Adjust the raster position per Section 2-8., only if this procedure was
not performed for full mode.
3. Adjust the geometry similar to Full DRC mode. Vertical size is 11.7
± 0.1 sq. and horizontal size is 15.6 ± 0.1 sq., if monoscope signal is
available. Otherwise, set the Vertical size to 91.0 ± 0.6% scan and
Horizontal size as 91.0 ± 0.6% scan.
4. Use the following register to adjust the horizontal parameter:
A2150-D2
Note: If necessary, touch up the geometry using the data register
listed above for Full mode.
5. Write the data into memory.
2-9.3. VERTICAL COMPRESSED MODE
CHECK AND CONFIRMATION
1. Input a monoscope and crosshatch signal.
2. Check vertical compressed mode.
— 17 —
KV-42DRC700
01 HPOS