Operating Modes - Würth 5700 103 Serie Manual De Instrucciones

 The extraction adapter may not be mounted
when no external dust extraction is connected.
Otherwise the extraction channel can become clogged.
 Do not connect a dust bag to the extraction
adapter. Otherwise the extraction system can become
clogged.
To ensure optimum extraction, the extraction adapter 29 must
be cleaned regularly.
External Dust Extraction
Connect the vacuum hose 30 to a vacuum cleaner (acces-
sory).
The vacuum cleaner must be suitable for the material being
worked.
When vacuuming dry dust that is especially detrimental to
health or carcinogenic, use a special vacuum cleaner.

Operating Modes

 Before any work on the power tool, remove
the battery.
Adjusting the Cutting Depth
(see figure C)
 Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth of the blade teeth
should be visible below the workpiece.
Loosen wing bolt 17. For a smaller cutting depth, pull the
machine from the base plate 7; for a larger cutting depth,
push the machine toward the base plate 7. Adjust the desired
cutting depth at the cutting-depth scale 18. Tighten wing bolt
17 again.
When setting the cutting depth, use the reference mark 31 to
the side of the cutting-depth scale 18.
Adjusting the Cutting Angle
It is best to place the machine on the face side of the blade
guard 13.
Loosen wing bolt 10. Tilt the saw sidewards. Adjust the
desired setting at the scale 9. Tighten wing bolt 10 again.
When setting the mitre angle, use the reference mark 27
(upper edge of the holder).
Note: For bevel cuts, the cutting depth is smaller than the set-
ting indicated on the cutting-depth scale 18.
Cutting Marks
The 0° cutting mark 12 indicates the position of the saw
blade for right-angled cuts. The 45° cutting mark 11 indi-
cates the position of the saw blade for 45° cuts.
Starting Operation
Inserting the battery
 Use only original Würth lithium-ion batteries
with the voltage listed on the nameplate of
your power tool. Using other batteries can lead to
injuries and pose a fire hazard.
Insert the charged battery 1 from the front into the base of the
power tool. Push the battery completely into the base until the
red stripe can no longer be seen and the battery is securely
locked.
Switching On and Off
To start the machine, first push the lock-off button for the
On/Off switch 3 and then press the On/Off switch 4 and
keep it pressed.
To switch off the machine, release the On/Off switch 4.
Note: For safety reasons, the On/Off switch 4 cannot be
locked; it must remain pressed during the entire operation.
To save energy, only switch the power tool on when using it.
Run-on Brake
An integrated run-on brake reduces the run-on period of the
saw blade after switching off the machine.
Temperature Control/
Overload Protection Indicator
The red LED indicator 16 will help you in protecting the bat-
tery against overheating and the motor against overloading.
When the LED indicator 16 continuously lights up red,
the temperature of the battery is too high and the machine
switches off automatically.
• Switch the power tool off.
• Allow the battery to cool down before continuing to work.
The LED indicator 16 flashes red, the power tool is blocked
and switches off automatically.
Remove the power tool from the workpiece.
The power tool will continue to work as soon as the blockage
is rectified.
Protection Against Deep Discharging
The lithium-ion battery is protected against deep discharging
by the "Electronic Cell Protection (ECP)". When the battery is
empty, the machine is switched off by means of a protective
circuit: The inserted tool no longer rotates.
22