Inserting Batteries In The Remote Control; Connecting The Antenna; Connecting The Power Supply; Switching The Smart Tv On And Off - Medion LIFE X14330 Guía Rápida

3.3. Inserting batteries in the remote control

 Remove the battery compartment cover on the back of the remote control.
 Insert two LR03 (AAA) 1.5 V batteries in the battery compartment of the remote control. Check
the battery polarity (see label on the bottom of the battery compartment).
 Close the battery compartment.
NOTICE!
Risk of damage!
The remote control can be damaged by leaking batteries if not used for a long pe-
riod of time!
 Remove the batteries from the remote control if the device is not going to be
used for a long period.

3.4. Connecting the antenna

Your smart TV supports different antenna signals.
You can input the following image signals to the television through the socket labelled ANT.:
• Via analogue cable/an analogue house aerial
2
• Via a DVB-T2/ DVB-T
• Via a DVB-C 2 connection (digital cable connection)
 Insert the antenna cable either from the house aerial/analogue cable connection, a DVB-T anten-
na or the DVB-C connection in the antenna socket on the Smart TV.
You also have the option of connecting a digital satellite system to the socket labelled LNB.
 Screw a coaxial antenna cable's F connector onto the connector on the Smart TV.
To receive encrypted/subscription channels you will need to use a CI module (Con-
ditional Access Module) and an appropriate card. Insert a CI module (available in
specialist shops) in the slot provided for this purpose on the left-hand side of the
device (COMMON INTERFACE). You can then insert your provider's card in the CI
module.

3.5. Connecting the power supply

 Connect the mains plug on the device to an easily accessible 220 to 240 V ~ 50 Hz mains socket.
3.6. Switching the Smart TV on and off
 The device will be in standby mode as soon as you have connected the mains plug to the mains
socket.
 To switch on the device, press
− on the remote control: the standby/on button, one of the number buttons or one of the
  buttons;
P /
− on the device: the multifunction switch
 Use the standby/on button on the remote control to switch the device back into standby mode.
The device will be switched off, but will continue to use power.
2 This service must be available in your region.
antenna or
.
EN
9