Setting Up; Unpacking; Putting The Batteries Into The Remote Control; Connecting An Antenna - Medion MD 30325 Manual Del Usuario

S U
ETTING P
NOTE:
Read the Safety Information Chapter under all circumstances before bringing
the device into operation.

Unpacking

1. Have someone help you when unpacking the equipment.
2. Do not carry the equipment alone, otherwise it could fall or cause personal injury.
3. Open the box very carefully to prevent the equipment from being damaged. Damage can
occur if a knife with a long blade is used to open the box.
4. There are various small parts in the packaging (batteries, screws, etc.). Keep these out of the
reach of children. There is a risk of swallowing the parts.
5. Please keep the packaging material well and use it exclusively to transport the television.

Putting the batteries into the remote control

1. Remove the small cover on the battery compartment on the back of the
remote control.
2. Install two AAA size, type R03 batteries according to the correct
polarity (marked in the battery compartment).
3. Close the battery compartment.
ATTENTION!
Remove the batteries from the remote, if the device will not be used for a
longer period. The remote could be damaged by leaking batteries.

Connecting an antenna

Connect the aerial connection and the LCD-TV by means of a double
screened aerial cable (not supplied) when connecting the device to the
room aerial or cable system.

Connecting the power supply

Insert the plug on the supplied power cable into the connecting bush
(220-240 V ~ 50 Hz) on the device and insert the other end into an easily
accessible 230 V ~ 50 Hz power socket.
EN
9