geberit Sigma10 Instrucciones De Uso página 13

Operation
Place your hand in the detection range to
activate a flush. You do not need to touch
the actuator plate. The detection range
starts approximately 15 cm in front of the
actuator plate.
• For a long flush, keep your hand in the
detection range for approx. 0,5 to
1 second
• For a short flush, keep your hand in the
detection range for approx. 1 to
2 seconds
B1074-002 © 04-2013
966.230.00.0 (01)
Deactivating automatic flush
actuation
The preset automatic flush actuation can be
deactivated at any time. This change can be
carried out by the operator or user.
Prerequisites
The WC flush control is ready for operation.
The power supply to the unit must be
interrupted. A size 2 Torx® key is included
for this purpose (only with screwed actuator
plates).
The same procedure can be used to
reactivate the automatic flush
actuation after it has been
deactivated. Successful reactivation
is signalled by the sounding of
5 single tones.
1
2 mm
EN
13