Parts And Their Functions - Korg MIKU STOMP Manual Del Usuario

Parts and their functions

1. Effect switch: The effect
turns on/off each time you
press this switch. When on,
Hatsune Miku vocalizes the
notes you play; when off, the
effect is bypassed. This is a
true bypass that does not
send the signal through any
electronic circuitry.
2. Effect LED: This LED is lit
when the effect is on. It is
unlit when the effect is off
(bypassed).
If the effect LED continues
blinking in groups of two blinks,
the batteries have run low.
Please replace the batteries as soon as possible.
3. Selector: This selects what Hatsune Miku vocalizes. Refer to
"Selector list" for more information.
4. Input jack: Connect your guitar to this jack.
The power turns on when you insert a plug into the Input jack,
and turns off when you remove the plug. When you're not using
the MIKU STOMP, unplug the cable that's connected to the Input
jack so that the batteries are not used unnecessarily.
5. Peak LED: This LED will light up when the guitar input level is
excessive. Adjust the level as described in "Tips for accurate
pitch detection" section of the manual.
7
2
6
5
3
4
1
19