Residual Risk; Transportation And Storage - Ryobi RLM18X40H240 Traducción De Las Instrucciones Originales

■ Stop the blade when crossing gravel
surfaces.
■ Do not pull the product backward unless
absolutely necessary. If you must back the
product away from a wall or obstruction,
first look down and behind to avoid tripping
or pulling the product over your feet.
■ Stop the motor and allow the blade to stop if
the mower has to be tilted for transportation
when crossing surfaces other than grass,
and when transporting the product to and
from the area to be mowed.
■ Never use the product with defective guards
or shields, or without safety devices, for
example, deflectors and/ or grass boxes,
in place.
■ Do not tilt the lawn mower when switching
on the motor or whilst the motor is running.
This exposes the blade and increases the
probability of objects being thrown.
■ Switch on the motor carefully according
to instructions and keep hands and feet
away from cutting area. Keep clear of the
discharge opening at all times. Do not start
the machine when standing in front of the
discharge opening.
■ Do not put hands or feet near or under
rotating parts. Keep clear of the discharge
opening at all time.
■ Never pick up or carry the product while it
is running.
■ Stop the mower motor and remove isolator
key, make sure that all moving parts have
come to a complete stop for the below
cases:
● whenever you
unattended (including disposal of grass
clippings).
● before cleaning a blockage or unclogging
discharge chute
● before checking, cleaning or working on
the product
● after striking a foreign object; inspect the
product for damage and make repairs
as necessary before restarting and
operating the machine.
● before removing the grass box or
opening the grass discharge chute
cover.
● If the machine
abnormally (check immediately)
leave the product
starts to vibrate
– inspect for damage, particularly the
blades
– replace or repair any damaged parts
– check for and tighten any loose parts
■ Avoid holes, ruts, bumps, rocks, property
stakes, or other hidden objects. Uneven
terrain could cause a slip and fall accident.
ADDITIONAL BATTERY SAFETY
WARNINGS
WARNING
To reduce the risk of fi re, personal injury,
and product damage due to a short circuit,
never immerse your tool, battery pack or
charger in fl uid or allow a fl uid to fl ow inside
them. Corrosive or conductive fl uids, such
as seawater, certain industrial chemicals,
and bleach or bleach-containing products,
etc., can cause a short circuit.

RESIDUAL RISK

Even when the product is used as prescribed,
it is still impossible to completely eliminate
certain residual risk factors. The following
hazards may arise in use and the operator
should pay special attention to avoid the
following:
■ Injury caused by vibration. Always use
the right tool for the job, use designated
handles and restrict working time and
exposure.
■ Exposure to noise can cause hearing injury.
Wear ear protection and limit exposure.
■ Contact with blades
■ Injury from thrown objects

TRANSPORTATION AND STORAGE

■ Stop the machine, remove the isolator
key and the battery, make sure that all
moving parts have come to a complete
stop, and allow it to cool before storing or
transporting.
■ Clean all foreign material from the machine.
Store it in a cool dry and well-ventilated
place that is inaccessible to children. Keep
away from corrosive agents such as garden
chemicals and de-icing salts. Do not store
outdoors.
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
English | 3