Symbols In This Manual; Residual Risks; Maintenance; Clearing Blockages - Ryobi ROBOYAGI 800 Traducción De Las Instrucciones Originales

EurAsian Conformity Mark
Ukrainian mark of conformity
Recycle raw materials instead of
disposing of as waste. The machine,
accessories, and packaging should
be sorted for environmental-friendly
recycling.
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or
retailer for recycling advice.

SYMBOLS IN THIS MANUAL

Parts or accessories sold separately
Note
Warning

RESIDUAL RISKS

Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise during use
and the operator should pay special attention to avoid
the following:
■
injury from contact with the blades
■
injury caused by thrown objects

MAINTENANCE

WARNING
Use only original manufacturer's replacement parts,
accessories and attachments. Failure to do so
can cause possible injury, can contribute to poor
performance, and may void your warranty.
WARNING
Servicing requires extreme care and knowledge
and should be performed only by a qualifi ed service
technician. For servicing and repairs, have the
product serviced by an authorised service centre only.
When servicing, use only original replacement parts.
10
■
Turn off the master switch and remove the battery
pack. Make sure that all moving parts have
come to a complete stop before any cleaning or
maintenance task.
■
You may make adjustments and repairs described
in this manual. For other repairs, have the product
serviced by an authorised service centre only.
■
Replace worn or damaged parts for safety.
■
Clean the product once a week with a soft, dry
cloth. Any part that is damaged should be properly
repaired or replaced by an authorised service
centre.
■
Perform weekly checks on the blade disc screws,
blade nuts, and blade screws to ensure proper
tightness. Check all other nuts, bolts, and screws
monthly for proper tightness to ensure the product
is in safe working condition.
■
Be careful during adjustment of the product to
prevent entrapment of the fi ngers between moving
blades and fi xed parts of the product.
■
When servicing the blades, be aware that even
though the power source is turned off, the blades
can still be moved.
■
The blade on the product is sharp. Use extreme
caution and wear heavy-duty gloves when fi tting,
replacing, cleaning, or checking bolt security.
■
Replace damaged blades and bolts in sets to
preserve balance.
■
The blade bolts must be adequately tightened.
■
Keep the blades sharp and clean to prevent loss
of control.
■
Remove the charging port, then install the winter
cap for winter. See page 432 "Removing the
charging port for winter."

CLEARING BLOCKAGES

■
Turn off the master switch and remove the battery
pack. Make sure that all moving parts have come to
a complete stop.
■
Always wear heavy-duty gloves when checking or
clearing a blockage.
■
The blades are sharp and the blockage itself could
be a sharp object.
WARNING
Use extreme caution when lifting or tilting the product
for maintenance, cleaning, storage, or transportation.
The blade is sharp. Keep all body parts away from
the blade while exposed.

PERFORMING INSTALLATION CHECKS

See pages 402 - 403