8. Slide the washer/dryer to its final
location.
9. Follow the Installation Instructions
that came with your appliance to
finish installing or reinstalling your
washer/dryer (i.e., hoses, vents,
etc.).
10. Adjust front feet to level washer/
dryer.
Note: Correct adjustment of feet
(equal weight distribution to all
feet) is required to insure minimal
movement (walking) of washer
during operation.
11. Use supplied open-end wrench to
securely tighten both front feet
locknuts against the pedestal. All
locknuts must be tightened.
12. SLIDE BALL BEARING RAILS
TO FRONT (see Figure 10).
WARRANTY
Full One-Year Warranty on Mechanical Parts
For one year from the date of purchase, when this pedestal is installed with the listed washer or dryer and operated
according to the instructions provided in the washer or dryer Operating, Care and Installation Instructions, supplier will
repair or replace any of its mechanical parts if defective in material or workmanship.
Warranty Restriction
If the Pedestal is subject to other than private family use and/or used with any other product than those listed in the
Installation Instructions, the warranty is null and void.
Warranty Service
Warranty service is available by contacting the retailer where the Pedestal was purchased. If retailer is not available, please
refer to the Operating, Care and Installation Instructions that came with the washer or dryer that is installed with the
Pedestal and contact the service department listed there.
This warranty applies only while the Pedestal is in use in the United States or Canada*. This warranty gives you specific
rights and you may also have other rights which vary from state to state or province to province.
*Warranty terms may vary in Canada.
In the space below, record the purchase date of your pedestal and model and serial number of the appliance on which the
pedestal is installed.
Save these instructions and your sales receipt for future reference.
Purchase Date
Washer/Dryer Model Number
Washer/Dryer Serial Number
4
Figure 10
13. Ensure slides of pedestal and
drawer are aligned correctly (see
Figure 11).
Incorrect
Correct
Figure 11
14. Reassemble the drawer to the
drawer slides.
Close the drawer.
Ensure drawer slides are correctly
engaged by freely opening and
closing the drawer.
CA
CAUTION
CA
UTION
UTION
UTION
CA
CA
UTION
Do not use drawer as a step.
For problems with or service on your
pedestal contact BSH Home
Appliances. Contact information is
available in the "Customer Service"
section of the appliance manual.
8403
9000017852