DeWalt DCBL590 Guía De Montaje

FIG. 1
Joystick Tube Assembly
Assemblage du tuyau du manche
Unidad del tubo joystick
FIG. 2
G
H
J
FIG. 4
G
DCBL590
Assembly Guide
K
Blower Assembly
Assemblage du souffleur
Unidad del soplador
FIG. 3
U
W
F
Read instructions before removing blower from the box.
WARNING:
the risk of injury, and for complete
product instructions,
warnings, and cautions, read the
instruction manual.
WARNING:
O
any batteries until the blower is fully
assembled.
REMOVING BLOWER FROM
BOX (FIG. 1)
NOTE: The blower assembly and joystick tube
assembly are attached when shipped. Trying
to pull one side out without the other may
result in damage to the cable (K).
1. Simultaneously grab the blower handle (O)
and the joystick tube assembly and remove.
2. Cut the plastic zip tie that is tethering the
joystick to the blower.
3. Remove the rest of the parts and assem-
ble as instructed below.
ASSEMBLY (FIG. 2 - 4)
CAUTION:
selection switch is in the center "OFF" position
to prevent the blower from actuating and the
battery is removed before attaching or removing
the tubes. The tubes must be fully assembled
before use.
Tube Assembly
ATTACHING FLEXIBLE TUBE TO ELBOW
TUBE (FIG. 2, 3)
1. Remove the tube clamp with cable clip (J)
from the flexible tube (G). Note the orienta-
tion of the clamp because it needs to be
reinstalled later in this same orientation.
2. Slide the flexible tube over the elbow tube
V
(H) as shown in figure 2.
3. Keeping the clamp in the same orienta-
tion as it was before removing it from the
flexible tube, pull open the clamp with
cable clip and wrap it around the flexible
tube where it attaches to the elbow tube
as shown in figure 3.
4. Slide the clamp bolt (U) through the
clamp. Thread the hex nut (V) onto the
clamp bolt by hand.
5. Using the hex wrench, tighten the bolt until
the clamp holds the flexible tube securely
to the collar and joystick tube. DO NOT
OVERTIGHTEN. Overtightening the
clamp could result in damage to the tool.
ATTACHING FLEXIBLE TUBE TO JOYSTICK
To reduce
TUBE (FIG. 4)
1. Remove the tube clamp from the flexible
safety
tube (G).
2. Insert the tube collar (W) at the end of the
joystick tube (F) into one end of the flex-
ible tube as shown in figure 4.
Do not insert
3. Pull open the tube clamp and wrap it
around the flexible tube where it overlaps
the tube collar.
4. Slide the clamp bolt (U) through the
clamp. Thread the hex nut (V) onto the
clamp bolt by hand.
5. Using the hex wrench, tighten the bolt
until the clamp holds the flexible tube
securely to the collar and joystick tube.
DO NOT OVERTIGHTEN. Overtightening
the clamp could result in damage to the
tool and will restrict the movement of
the joystick tube.
WARNING:
the risk of injury, and for complete
product
warnings, and cautions, read the
instruction manual.
Ensure the battery-
To reduce
instructions, safety