External Battery Connection - Tripp-Lite SmartOnline SUINT3000RTXL2U El Manual Del Propietario

4. Installation

External Battery Connection

3
Check to ensure the external batteries being
connected match the voltage listed on the UPS
battery connector. Adding external batteries will
increase recharge time as well as runtime. See
the battery pack owner's manual for complete
installation instructions. Make sure cables are
fully inserted into their connectors. Small sparks
may result during battery connection; this is
normal. Do not connect or disconnect battery
packs when the UPS is running on battery power.
Accessory Card Slot
4
The slot accommodates an optional internal
accessory card (model WEBCARDLX, sold
separately). WEBCARDLX provides an Ethernet
network interface for remote monitoring and
control of the UPS system via SNMP , Web or
telnet. WEBCARDLX enables remote reboots,
shutdowns, load monitoring, condition reporting
and more.
Remove the cover panel from the slot to insert
the accessory card. Refer to the WEBCARDLX
documentation for additional installation
instructions.
18-09-247-933652.indb 9
3
4
9
2/13/2019 3:27:29 PM