Product Information; Declaration Of Conformity; Scope Of Delivery; Definition - Bosch Heat Convector 4000 Manual Del Usuario

Product Information

H Risk of overheating, risk of fire
To reduce the risk of fire:
▶ Maintain a clearance of at least 1 m
between the air outlet and textiles,
curtains or other combustible
materials.
▶ Do not place anything on the
convector. Do not cover the convector
or climb onto it.
▶ Ensure that the heat transfer from the
convector is unhindered.
▶ Only use the product on a horizontal
stable surface or fasten it to the wall.
H Danger to life from electric shock!
Touching a defective product or
connecting lead may result in electric
shock.
▶ Do not use the product if it has been
dropped.
▶ Do not use the product if there are
visible signs of damage.
▶ Do not open the product.
▶ Avoid carrying out any interventions.
▶ Stop using the product and
disconnect it from the mains power
supply.
▶ Please contact Service.
You can find the service addresses in
chapter 10, page 67.
-or-
▶ Dispose of the product properly.
58
2 Product Information
These instructions contain important information for the
system user regarding safe operation of the Heat Convector
4000.
The convector must only be set up or mounted outside the
safety zone (shown in grey  Fig. 3, page 211).
For this:
▶ observe the installation instructions.
2.1

Declaration of conformity

The design and operating characteristics of this product
comply with the European and national requirements.
The CE marking declares that the product complies
with all the applicable EU legislation, which is
stipulated by attaching this marking.
The complete text of the Declaration of Conformity is available
on the Internet: www.bosch-thermotechnology.com.
2.2

Scope of delivery

▶ Check packaging upon receipt of delivery for damage.
▶ Check the scope of delivery for completeness.
– Heat Convector 4000
– Technical documentation
2.3

Definition

The Heat Convector 4000 is subsequently referred to in this
document as "product", "convector" or "appliance".
2.4

Intended use

The convector is intended for heating of living spaces.
▶ Comply with the connection conditions in accordance with
the specifications, standards and regulations of the
relevant country.
▶ The convector must only be set up or mounted outside the
safety zone (shown in grey  Fig. 3, page 211).
Any other purpose is considered improper use. Any damage
that results from such use is excluded from liability.
Heat Convector 4000 – 6720883017 (2020/05)