PACK (See Fig. C)
Depress the battery release button (6) to
release battery pack from your tool. After
recharging, insert the battery pack into
tool's battery port. A simple push and slight
pressure will be sufficient.
4. STARTING/STOPPING (See Fig. D)
Starting
Move the On/Off switch (2) to the "I" On
position.
Stopping
Move the On/Off switch (2) to the "O" Off
position.
wARNING! The tool runs for a few
seconds after it has been switched off.
Let the motor come to a complete standstill
before setting the tool down.
5. USING THE BLOwER (See Fig. E)
The blower is intended for residential use
only. Use the blower outdoors to move
debris from hard surfaces. This blower is not
designed to clear leaves from large grassy
areas, or move wet, heavy debris.
USER TIPS
-
Hold the blow tube approx 180mm above
the ground when operating the tool.
14
Use a sweeping motion from side to side.
Advance slowly keeping the accumulated
debris/leaves in front of you.
-
After blowing the debris/leaves into a pile,
it is easy to dispose of the pile.
CAUTION!
Do not blow hard objects such as
-
nails, bolts, or rocks.
Do not operate the blower near
-
bystanders or pets.
Use extra care when cleaning debris
-
from stairs or other tight areas.
wear safety goggles or other suitable
-
eye protection, long pants, and shoes.
Cordless Li-ion Blower/Sweeper
CLEAninG THE TOOL
Clean the tool regularly.
wARNING: Keep your product dry.
Under no circumstances spray with water.
-
To clean the tool, use only mild soap and a
damp cloth.
wARNING: Do not use any type of
detergent, cleaner or solvent which
may contain chemicals that could seriously
damage the plastic.
-
Self lubricating bearings are used in
your product, therefore lubrication is not
required.
EnViROnMEnTAL
PROTECTiOn
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
En