Cleaning The Tool; Environmental Protection - Worx WG568E Manual Del Usuario

3. tO rEMOVE Or iNStaLL BattEry
PaCK (See Fig. C)
Depress the Battery Release Button (9) to
release battery pack from your tool. After
recharging, insert the battery pack into
tool's battery port. A simple push and slight
pressure will be sufficient.
4.BattEry StatUS LED'S (See Fig. D )
NOtE: the Status LED's will indicate the
battery condition when the button on the
battery is pressed.
The LED's constantly senses and displays the
battery condition as follows:
Press the button "POWERTEST" , the light
button is illuminated.
When the three green lights are illuminated,
the battery is in a highly charged condition.
When two lights (
battery is in a moderately charged condition.
When only one green light (
the battery charge is depleted.
iMPOrtaNt:
when only one light is illuminated,
your battery is overly discharged, even
12 though the blower may still be capable
of blowing debris. Continuing to operate
your blower with the battery in this
discharged condition may reduce the life
and performance of your battery.
5. StartiNG/StOPPiNG (See Fig. E)
Your blower is fitted with a variable speed
control through the trigger. Depress the Lock
OFF switch and the variable speed trigger to
start your blower. To switch off, just release the
variable speed trigger.
warNiNG! The tool runs for a few
seconds after it has been switched off.
Let the motor come to a complete standstill
before setting the tool down.
6. USiNG tHE BLOwEr (See Fig. F)
The blower is intended for residential use
only. it is fitted with a high speed nozzle. For
wet leaves, use the high speed nozzle for ideal
clean during operating the blower.
Cordless Li-ion Blower/Sweeper
) are illuminated, the
) is illuminated,
USEr tiPS
- Hold the blow tube approx 180mm above
the ground when operating the tool.Use
a sweeping motion from side to side.
Advance slowly keeping the accumulated
debris/leaves in front of you.
- After blowing the debris/leaves into a pile,
it is easy to dispose of the pile.
CaUtiON!
- Do not blow hard objects such as
nails, bolts, or rocks.
- Do not operate the blower near
bystanders or pets.
- Use extra care when cleaning debris
from stairs or other tight areas.
- wear safety goggles or other suitable
eye protection, long pants, and
shoes.

CLEANiNG THE TOOL

CLEaN tHE tOOL rEGULarLy.
warNiNG! Keep your product dry.
Under no circumstances spray with
water.
- to clean the tool, use only mild soap
and a damp cloth.
- Do not use any type of detergent,
cleaner or solvent which may contain
chemicals that could seriously
damage the plastic.
- Self lubricating bearings are used in
your product, therefore lubrication is
not required.
ENViRONMENTAL
pROTECTiON
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
EN