Satco NUVO S28931 Instrucciones De Instalación

HI-PRO LED SHOE BOX LAMPS
Models: S28931, S28932, S28937, S28938
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fi xture. Retain for future reference.
WARNING:
Risk of Fire or Electric Shock
• Please read this manual carefully before use. Make sure the application is in accordance with the instructions before use.
• Luminaire wiring and electrical parts may be damaged when drilling for installation of LED retrofi t kit. Check for enclosed
wiring and components.
• To reduce the risk of electric shock and fi re, this lamp must be installed, tested and maintained by professionals using
special equipment.
• Do not operate lamps on existing ballasts. These LED lamps require all the ballasts, capacitors, and ignitors to be
bypassed or removed.
• Suitable for dry and damp locations. Do not use where directly exposed to water.
• Do not use with dimmers or attempt to dim.
• Added weight of the device may cause instability of a free-standing portable luminaire.
• This device is not intended for use with emergency exits.
• Install this kit only in luminaires that have the construction features and dimensions shown in the photographs and/or
drawings and where the input rating of the retrofi t kit does not exceed the input rating of the luminaire.
• When using in portable table luminaires, ensure the distance from the bottom of the base to the top of the lampholder
does not exceed three (3) times the base diameter.
• Before installation make certain the AC power to the fi xture is off.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
• Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
• Installers should not disconnect existing wires from lamp holder terminals to make new connections at lamp holder terminals.
Instead installers should cut existing lamp holder leads away from the lamp holder and make new electrical connections to
lamp holder lead wires by employing applicable connectors.
• For use in enclosed fi xtures.
Watts Volts (VAC)
80W
100 – 277V
110W
INSTALLATION
Each lamp can be controlled with optional interface accessories or with standard On/Off functions.
1
STEP 1: Turn off the power before installation.
Remove the old ballast, capacitor and ignitor
(if existing). See Figure 1.
INSTALLATION USING SUPPORT STAND
For installation in downward horizontal fi xture, use support with double
"prongs." Cut to desired length after installation. See illustration below.
Optional Hi-Pro Intelligent Interface Accessories:
80-954
WiFi Module
© Copyright 2020 Satco Products, Inc. 1/20
Base Dimensions (Inches)
8.74" x 4.37" x 4.65"
E39
11.1" x 4.37" x 4.65"
2
STEP 2: Make sure the Alternating Current
Wires connect to the E39 socket directly.
Reattach or replace ground lead if one is
needed. See Figure 2.
80-956 80-957
Photocell Motion Sensor/MW
Min. Compartment Operating Temperature
11" x 11" x 9.2"
–30ºC to 45ºC (–22ºF to 113ºF)
11" x 11" x 11.3"
3
STEP 3: Screw the LED lamp onto the
corresponding socket. See Figure 3.
WARNING:
Both sides of the lamp must be extended
in order to operate.
• Place lamp in the • Adjust lamp so
fi xture and screw center panel is
into socket. facing toward the
front, then unfold
side panels down.
TYPE
B
• Finish installation
with the mounting
bracket and
replace the fi xture
lens.
Satco Products, Inc.
Brentwood, NY 11717