Publicidad
Idiomas disponibles
Idiomas disponibles
W A R N I N G S , C A U T I O N
& L E G A L I N F O R M A T I O N
To reduce the risk of fire or electric shock, do
not expose the BRAVEN to rain or moisture while
charging. The BRAVEN should not be exposed
to dripping or splashing, and objects filled with
liquids, such as vases, should not be placed on
or near it while being charged or charging other
devices. As with any electronic products, use care
not to spill liquids into any part of the product.
Liquids can cause a failure and/or a fire hazard.
The power supply must be used indoors only. Make
no modifications to the product or accessories.
Unauthorized alterations may compromise safety,
regulator y compliance, and system performance,
and will void the warranty. Do not place any flame
sources, such as lighted candles, on or near the
BRAVEN. The BRAVEN contains small parts that
may be a choking hazard and is not suitable for
children under age 3. Do not continue charging the
batter y if it does not reach full charge within the
specified charging time. Overcharging may cause
the batter y to become hot, rupture, or ignite. If
you see any heat deformation or leakage, properly
dispose of the batter y. Do not attempt to charge
the batter y in temperatures outside the range of
32°-104°F (0°-40°C). If the batter y begins to leak,
do not allow the liquid to come in contact with
your skin or eyes. If contact has been made, wash
the affected area with plenty of water and seek
medical attention immediately. Do not expose the
product or batter y to excessive heat, including
direct sunlight or fire and storage or use inside
cars in hot weather, where it can be exposed to
temperatures in excess of 115°F (60°C). Doing
so may cause the batter y and power supply
to generate heat, rupture, or ignite. Using the
product in this manner also may result in a loss
of performance and a shortened life expectancy.
Extended exposure to direct sunlight may damage
the external appearance and material qualities.
Do not step on, throw, or drop batteries or the
power supply or device, or expose them to a strong
shock. Do not pierce, crush, dent, or deform the
batteries or power supply in any way. If either
becomes deformed, properly dispose of it. Do
not short-circuit batteries. Do not attempt to
ser vice the BRAVEN yourself. Opening or removing
covers may expose you to dangerous voltages or
other hazards and will void the manufacturer's
warranty. To prevent risk of fire or electric shock,
avoid overloading wall outlets, extension cords, or
integral convenience receptacles. Your Bluetooth
device (mobile phone, music player, tablet, laptop,
etc.) must support the A2DP Bluetooth profile in
order to work wirelessly with your new BRAVEN
speaker. The A2DP profile is supported by most
recent mobile products with built-in Bluetooth
capability. Please refer to your device's user
manual for details and instruction regarding
the Bluetooth profiles it supports. This device
complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
tr y to correct the interference by one or more of
the following measures:— Reorient or relocate
the receiving antenna. —Increase the separation
between the equipment and receiver. — Connect
the equipment into an outlet on a circuit different
from that to which the receiver is connected. —
Consult the dealer or an experienced radio/ TV
technician for help.
This device complies with Industr y Canada
license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation
of the device. Under Industr y Canada regulations,
this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industr y Canada.
To reduce potential radio interference to other
users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated
power (e.i.r.p.) is not more than that necessar y for
successful communication.
Lithium Batter y installed is not intended to be
replaced by the USER.
CAUTION: Danger of explosion if batter y is
incorrectly replaced. Replace only with the same
or equivalent type.
Where the MAINS plug is used as the disconnect
device, the disconnect device shall remain readily
operable.
Correct Disposal of this product. This marking
indicates that this product should not be disposed
with other household wastes throughout the EU.
To prevent possible harm to the environment or
human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable
reuse of material resources. To return your used
device, please use the return and collection
systems or contact the retailer where the product
was purchased.
This product complies with California Energy
Commission efficiency standards for consumer
batter y chargers.
E N G L I S H
|
6
Publicidad
