Initial Use; Setting Up The Products; Operating The Outdoor Sensor; Operating The Weather Station - Auriol HG06061A-US Instrucciones De Utilización Y De Seguridad

Note: First insert the batteries in the outdoor sensor, then the
main station.
ATTENTION: First start the outdoor sensor, then the main station.
You can either operate the weather station with the included power
adapter
337765_1907_aur_Funk-Wetterstation_Content_US.indd 17

Initial use

Setting up the products

If possible, do not expose the outdoor sensor to direct sunlight.
Place the main station on a horizontal, level surface or mount
to a plumb wall.
The outdoor sensor can be hung by the hanger
on a horizontal, level surface.

Operating the outdoor sensor

Open the battery compartment
by pushing the battery compartment cover
of the arrow.
Insert two type AAA batteries into the battery compartment
as shown.
Close the battery compartment
on the front of the outdoor sensor lights up briefly. Afterwards,
the control LED
19
transmission is taking place.

Operating the weather station

or using batteries.
14
on the rear of the device
25
again. The control LED
25
lights up once every minute to signal that
or place it
21
in the direction
26
25
19
US-EN 17
13.01.20 10:19