Kobalt KCOT 124B-03 Manual Del Usuario página 10

OPERATING INSTRUCTIONS
3. LED Worklight
The LED worklight (E), located on the front of the
cut-out tool, will illuminate when the trigger switch
is depressed. This provides additional light on the
surface of the workpiece for operation in lower-light
conditions. The LED worklight will automatically
turn off approximately 10 seconds after the trigger
has been released.
a. The LED worklight will blink rapidly if the tool
has stopped working in order to protect internal
circuits; please wait for the tool to cool down, at
which point it can be started again.
b. The LED worklight will blink slowly to indicate
that the battery charge is very low.
4. Installing and Removing the Belt Clip
a. Align the rib of the belt clip (L) with the hole
on the base of the cut-out tool.
b. Insert the screw (M) and tighten the screw
securely with a Phillips screwdriver
(not included).
c. To remove the belt clip, use a Phillips
screwdriver (not included) to loosen the screw
holding the belt clip to the cut-out tool.
5. Cutting Depth Adjustment
WARNING
• Always remove battery pack before changing or
removing accessories or make any adjustments.
Adjust the depth guide before each cut.
a. Loosen the thumb screw (B).
b. Slide the cutting depth guide (A) to the desired
position and then tighten the thumb screw
securely.
c. Ensure that the depth guide is securely locked
in place before use.
Check for the proper clearance beneath the workpiece before cutting. For best results, set the
depth guide so that the cutting bit extends 1/8" beyond the workpiece.
3
E
4
5
A
10
L M
B