Operating Instructions - Kobalt KCOT 124B-03 Manual Del Usuario

OPERATING INSTRUCTIONS

1. To Attach Battery Pack
a. Press the ON/OFF switch (G) in the center/off
position.
b. Align the raised portion on the battery pack
with the grooves on the bottom of the tool, then
slide the battery pack onto the tool, as shown.
c. Make sure that the latches on the battery pack
snap into place and the battery pack is secured
to the tool before beginning operation.
NOTICE: When placing the battery pack on the
tool, be sure that the raised rib on the battery pack
aligns with the groove on the tool and the latches
snap into place properly. Improper assembly of
the battery pack can cause damage to internal
components.
To Detach Battery Pack
a. Press the ON/OFF switch (G) in the center/off position.
b. Press the battery-release buttons to release the battery pack.
c. Pull forward on the battery pack to remove it from the tool.
WARNING
• Battery tools are always in operating condition. Therefore, always remove the battery pack
be in off position when the tool is not in use or when carrying it at your side.
2. ON/OFF Switch
a. To turn the cut-out tool ON, press the ON/OFF
switch (G) marked "I" to right side.
b. To turn the tool OFF, press the ON/OFF switch
marked "O" to the center position.
1
Battery-Release
Buttons
2
ON
9
G
G
OFF