Set-Up And Operation; Controls And Settings; Turning On And Off; Setting Measurement Reference Point - RIDGID micro LM-100 Manual De Instrucciones

micro LM-100 Laser Distance Meter
Figure 6 – Warning Labels

Set-Up and Operation

Do not look into the laser beam. Looking into the laser beam
may be hazardous to the eyes. Do not look at the laser beam
with optical aids (such as binoculars or telescopes).
Do not direct the laser beam towards other people. Make sure
the laser is aimed above or below eye level. Laser beams may
be hazardous to the eyes.
Set up and operate the distance meter according to these pro-
cedures to reduce the risk of injury or incorrect measurements.
1. Check for an appropriate work area as indicated in the General
Safety Section.
2. Inspect the object being measured to and confirm that you have
correct equipment for the application. The micro LM-100 Laser
Distance Meter is designed to measure distances up to 100 m
8
WARNING
(328 feet). See the Specifications section for range, accuracy
and other information.
3. Make sure that all equipment has been properly inspected.
micro LM-100 Controls and Settings

Turning ON and OFF

Press the ON/Measurement Button
meter and the laser. Make sure that the laser is pointed in a safe
direction before turning ON.
Press and Hold the Clear/Power OFF Button
meter OFF. The laser distance meter will turn OFF automatically
after three minutes of inactivity.

Setting Measurement Reference Point

When the distance meter is turned ON, the default measurement
reference point is the back edge of the meter
urement Reference Point Button
reference point to the front edge (laser end) of the meter. The meter
will beep and the display will show the reference point front symbol
.

Changing Display Units

Press and Hold the Backlight/Unit Change Button
display units. Available Units: Feet, Meters, Inches.
Clearing Displayed Data/Last Action
Press the Clear/Power OFF Button
or cancel the last action.

Reviewing the Last 20 Measurements

Press the Memory Button
to turn ON the distance
to turn the Distance
. Press the Meas-
to change the measurement
to change the
to clear the displayed data
to review the last twenty measure-
999-998-391.09_REV. D