Operation; Mma Welding; Tig Welding; Arc Air Gouging - ESAB Origo Arc 410c Instrucciones De Uso

GB
Frequency
Voltage
Current at
100% duty cycle
60% duty cycle
35% duty cycle
Fuse, slow
Cable area (4xmm2)
Frequency
Voltage
Current at
100% duty cycle
60% duty cycle
35% duty cycle
Fuse, slow
Cable area (4xmm2)
NB: The mains cable areas and fuse sizes as shown above are in accordance with Swedish
regulations. They may not be applicable in other countries: make sure that the cable area and fuse
sizes comply with the relevant national regulations.
6

OPERATION

Select suitable earth and return cables and connect them to the terminals
S
marked "+" (5) and "--" (6) on the front of the rectifier. Connect the return cable to
the work piece.
Set switch (1) to position "I". The lamp (3) will light, the fan and the contactor will
S
operate in several seconds.
6.1

MMA welding

Set switch (4) to
of sticking the electrode to workpiece during arc striking.
6.2

TIG welding

Set switch (4) to
torch switch is pressed. After arc initiation current rises from minimum possible value
until it reaches the value set by operator.
6.3

Arc Air Gouging

Set switch (4) to
maximum value in order to ensure proper gouging conditions.
Arce
TM
Origo Arc 410c
50 Hz
230/400--415/500 V
27/16/13 A
38/22/18 A
54/31/25 A
63/25/20 A
10/4/4
TM
Origo Arc 410c
60 Hz
230/440--460/550 V
27/14/12 A
38/20/16 A
54/28/23 A
63/25/20 A
10/4/4
. In MMA mode implicitly "anti stick" function is ON. It prevents
. In TIG mode output voltage of machine is ON after the welding
. In Arc Air Gouging mode current should be set close to
TM
Origo Arc 650c
50 Hz
230/400--415/500 V
57/33/26 A
69/40/32 A
109/63/50 A
80/50/35 A
25/10/6
TM
Origo Arc 650c
60 Hz
230/440--460/550 V
57/30/24 A
69/36/29 A
109/57/46 A
80/50/35 A
25/10/6
- - 8 - -
TM
Origo Arc 810c
50 Hz
230/400--415/500 V
71/41/33 A
99/57/46 A
130/75/60 A
100/63/50 A
35/10/10
TM
Origo Arc 810c
60 Hz
230/440--460/550 V
71/37/30 A
99/52/42 A
130/68/55 A
100/63/50 A
35/10/10