Operation; Connections And Control Devices - ESAB ESABMig 400t Instrucciones De Uso

GB
6

OPERATION

General safety regulations for the handling of the equipment can be found on
page 51. Read through before you start using the equipment!
WARNING – TIPPING RISK!
Fasten the equipment – particularly if the ground is uneven or sloping.
6.1

Connections and control devices

1 Connection for control cable to the wire
feed unit
2 MCB
3 Display (digital meters) is an accessory
see on page 198.
4 Orange indicating lamp, overheating and
loss of coolant*
5 White indicating lamp, power supply ON
6 Main supply switch
7 Main supply switch for cooling unit ELP**
NOTE! Cooling water connections only available on certain models.
* Indicating loss of coolant, only when water flow guard is used, see point 6.2.3
** ELP = ESAB Logic Pump, see point 6.2.2.
ba36d1ea
8 Connection for return cable (–),
low inductance
9 Connection for return cable (–),
medium inductance
10 Connection for return cable (–),
high inductance
11 Connection RED for cooling water from
the wire feed unit
12 Connection BLUE for cooling water to the
wire feed unit
13 Connection for weldng current cable (+)
– 58 –