Task 6: Connecting The Power - Promise Technology VTRAK E-Class E830f Guia De Inicio Rapido

VTrak E-Class Quick Start Guide

Task 6: Connecting the Power

Plug the power cords and turn on the switches on both power supplies.
When the power is switched on, the LEDs on the right handle light up.
Figure 15.Front panel LED display
FRU Status
Logical Drive Status
Controller 1 Activity
Controller 2 Activity
Controller Heartbeat
When boot-up is finished and the VTrak is functioning normally:
• Power, FRU and Logical Drive LEDs display green continuously.
• Controller Activity LEDs blink green when there is activity on the controllers.
• Controller Heartbeat LED blinks green once per second for five seconds,
goes dark for ten seconds, then blinks green once per second for five
seconds again.
There are two LEDs on each drive carrier. They report the presence of power and
a physical drive, and the current condition of the drive.
If you have a SAN, DAS, or Cascade with JBOD Expansion,
always power on the JBOD units first.
Power
Important
20