Task 5: Connecting The Power; Management Path - On Site Keyboard And Monitor; Important - Promise Technology Vess A2200 Guia De Inicio Rapido

PROMISE Technology
Figure 14: Ethernet ports on the rear panel of the Vess A2200/A2200s

Management Path - on site keyboard and monitor

Use a USB keyboard and a VGA or HDMI monitor to establish a direct out-of-band connection to the
embedded management software. The VGA port, HDMI and USB ports are also located on the rear panel of
the Vess A2200/A2200s, these are enabled by default upon booting up the system. Connect a VGA or HDMI
monitor to the ap-propriate port on the Vess A2200/A2200s, and connect a USB keyboard to either USB port
on the rear panel, and follow the instructions for using the text-based CLI or CLU interface for managing the
device.
Figure 15: Vess A2200/A2200s rear panel video monitor connections and USB ports
USB ports
Use to connect to
USB keyboard for
text input

Task 5: Connecting the Power

Insert one power cable into the power receptacle for each power supply and connect the each PSU to a
suitable power source. The Vess A2200s is equipped with a single power supply (see below). The Vess
A2200 is equipped with three power supplies in an N+1 arrangement. See "Figure 17: Vess A2200 rear panel
N+1 power connections" on page 13.
Ethernet ports
HDMI port
Connect to HDMI
monitor
Be sure to place the monitor and keyboard on a stable and secure surface before
connecting them to the Vess A2200/A2200s.
VGA port
Connect to VGA
monitor

Important

12