BEFORE YOU BEGIN
HOW TO USE THESE INSTRUCTIONS
Please read these instructions carefully to familiarize yourself with
the required tools, materials, and installation sequences. Follow the
sections that pertain to your particular installation. This will help you
avoid costly mistakes. In addition to proper installation, read all
operating and safety instructions.
NOTES
S
This instruction provides installation details for both
self-rimming and undercounter sink installations. Follow only
the steps that apply to your installation.
S
Due to the nature of undercounter installations, Kohler Co.
recommends that undercounter sink installations be
performed by trained and experienced installers.
S
To ensure a safe and damage-free installation, two people
should install the heavier sink models. Refer to the
approximate sink weights listed in the Specifications Section
on Page 2.
S
Observe all local plumbing and building codes.
S
Shut off the hot and cold water supplies.
TOOLS AND MATERIALS REQUIRED
S
Safety glasses
S
Pencil
S
Scissors
S
Tape measure
S
Putty knife
S
Plumbers putty
S
Hacksaw
S
Sealant
A
1007261-2-
SELF-RIMMING/UNDERCOUNTER
R
K-6558, K-6565, K-6584, K-6585,
Español, Página 9
Français, Page 17
1 1
ENAMELED CAST IRON
K-6586, K-6587, K-6588
All information in these instructions is based on the latest product
information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or
availability at any time without notice.
These instructions contain important care, cleaning, and warranty
information – please leave for the consumer.
S
Inspect the waste and supply tubing; replace as needed.
S
Prior to installation, unpack the new sink and carefully
inspect it for damage. Return the sink to its protective carton
until you are ready to install it.
S
For multiple-bowl installations, additional support will be
required between bowls installed in countertops that are less
than 1" (2.5cm) thick.
S
For multiple-bowl, undercounter installations, a
minimum distance of 3-3/8" (8.6cm) is required between
bowls.
S
A minimum countertop thickness of 1" (2.5cm) is required if
using the anchors provided.
S
Do not use adhesives or adhesive sealants with this
product.
S
Hole saw (1-3/8" dia.)
S
Keyhole saw or saber saw
S
Drill (1/2" dia. drill bit or larger)
S
Two adjustable wrenches
S
Pipe wrench
S
Tubing cutter
S
Masking tape (optional)
KITCHEN SINKS
E2001 Kohler Co.