When Using The Appliance For The First Time; How To Use - Panasonic ES-WH90 Instrucciones De Operación

When using the appliance for the first time

Check that the output level suits your skin.
Treated skin may temporarily turn red or feel painful depending
on the body type or condition of the person using the appliance.
Set the output level to 1 (LV1) and flash the treatment area
once.
After 2 days If there are no skin abnormalities
Set the output level to 1 (LV1) and start treatment on the
area that you want.
• Guide for treatment frequency, time (See page 14.)
If there are no skin abnormalities
After 2 weeks*
*For armpits/bikini line/face: after 1 week
To increase the output level for treatment, flash once on
the treatment area, and check your skin condition for
around 2 days before further treatment. Increase the
output level one step at a time.
• If there is intense pain or
redness after 2 or more
days, stop using the
appliance and consult a
dermatologist.
16
ES-WH90_EU.indb 16
<Output levels>
Greater treatment effects
LV5
LV4
LV3
LV2
LV1
Minimal pain or irritation

How to use

• The power will not turn on even when pressing the switch with
the AC adaptor connected to the main body.
• The appliance may not operate in an ambient temperature
approximately 5 °C or lower.
1
1
Remove the cap.
2
2
Attach the attachment to suit the area where you
want to use it.
3
3
Press and hold (for approximately 3 seconds)
to turn the power on.
• The power will turn off automatically if the appliance is not
used for approximately 1 minute.
4
4
Press to select the output level.
SELECT
• Level 1 is selected when the power is turned on.
• The level cycles through 1
time the level selector switch is pressed.
• The level indication lamp blinks, and then turns on. (A beep
sounds, indicating that preparation for flash is complete.)
2 3 4 5 1...each
2016/02/01 9:49:02