Service; Appliance-Specific Safety Instructions For Belt Sanders; Safety Information For Sanders; Operation - Parkside PBS 900 C3 Traducción Del Manual De Instrucciones Original

g) Use the power tool, accessories and tool
bits, etc. in accordance with these instruc-
tions, taking into account the working condi-
tions and the work to be performed. Use of
the power tool for operations different from
those intended could result in a hazardous
situation.

5. Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
Appliance-specific safety instructions
for belt sanders
■ Hold the appliance by the insulated handles
since the grinding belt can come into contact
with its own power cable. Damage to a live
wire may make exposed metal parts of the power
tool live and could give the operator an electric
shock.

Safety information for sanders

WARNING!
■ Dusts from materials such as leaded paint,
some types of wood and metal can be harm-
ful to your health.
■ Contact with or inhalation of these dusts can
represent a health hazard for the person
operating the appliance and other people in
the vicinity.
■ Wear safety goggles and a protective dust
mask!
PBS 900 C3

Operation

Tensioning/replacing the abrasive
belt
WARNING! RISK OF INJURY
■ Always remove the power plug from the wall
socket before carrying out any work on the
belt sander.
1. Loosen the clamping device for the abrasive
belt by swivelling the clamping lever
way out (see fig. A). The clamping device is
now open and the abrasive belt can be re-
moved.
2. Now fit a new abrasive belt or swap the belt
to work a different material or to use a different
grain size. IMPORTANT: The direction of the
arrows on the inside of the abrasive belt and
on the appliance housing must match.
3. Push the clamping lever
position.
Adjusting the abrasive belt:
♦ Pick up the appliance, switch it on and turn it
over. Adjust the belt tracking. To do this, turn
the adjustment screw
abrasive belt is flush with and runs parallel to
the appliance edge (fig. B). IMPORTANT:
It is important to ensure that the abrasive belt
does not rub against the housing. Check the
belt tracking regularly and adjust it with the
adjusting screw if required
all the
back into its initial
until the edge of the
.
GB │ IE │ 15 ■