Wet Pickup; Draining The Recovery Tank - Uline H-9933 Manual De Instrucciones

WET PICKUP

NOTE: This vacuum includes a blue nylon mesh
filter (Uline model # H-9933-WFBB). This filter
must be used in all wet pickup applications.
Failure to use the filter will void warranty on
vacuum motor.
NOTE: Ensure handle is properly assembled
on machine body prior to operating.
1. Remove vacuum head and remove the cloth or
paper filter from vacuum. Install blue nylon mesh
filter. (See Figure 5)
2. While vacuum head is removed, check to make
sure that the float shut-off is unobstructed and fully
functional.
3. Reattach vacuum head and latch it in place.
4. Connect vacuum hose to inlet on the machine body.
5. Attach appropriate accessory tool for the job to be
completed.
6. Plug power cord into a grounded outlet.
NOTE: Do not use an extension cord in
conjunction with standard power cord.
7. If using the front-mounted squeegee assembly, be
sure that squeegee is attached to front of machine.
8. If using the front-mounted squeegee assembly,
lower squeegee to the floor by depressing the top
half of the pedal (rear of the machine) forward with
your foot.
9. Turn power switch to "on" position.
10. During wet pickup, the float shut-off will
automatically prevent water from entering the
recovery tank once the recovery tank is full.
NOTE: If foam develops in the recovery
tank during wet vacuuming, use de-foamer
chemical to help eliminate the foam. Foam will
not activate the float shut-off and may cause
vacuum motor damage.
11. To raise the squeegee assembly back to transport
position, depress the bottom half of the pedal
(rear of the machine) downward with foot.
PAGE 3 OF 15
OPERATION
Figure 5
Power
Switch
Power Cord
Drain
Hose

DRAINING THE RECOVERY TANK

1. Unplug machine from power outlet.
2. Transport machine to nearest floor drain or bucket.
3. Remove drain hose from rear of machine. Remove
cap from drain hose and drain the contents of the
tank.
4. After the contents have drained, remove the
vacuum head and rinse recovery tank with clean
water.
5. Reattach cap on the drain hose and hang hose
back on the rear of the machine.
NOTE: To prevent odors in recovery tank,
remove vacuum head when machine is
not in operation to allow air to circulate.
Vacuum Head
Nylon Mesh Filter
Float Shut-off
Hose Inlet
Latch
Front Mounted
Squeegee
0222 IH-9933